Garbage Disposal Service
Repair or swap — done in one visit.
Garbage disposals are cheap to buy and expensive to install wrong. When yours is humming but not turning, leaking from the bottom, or tripping the reset, we diagnose in ten minutes and fix in under an hour. When it's beyond saving, we install a new one with a code-correct air gap and a fresh trap.
- Jammed, humming, or dead disposal diagnosis
- Leak repair (flange, gasket, housing)
- New disposal install (1/2, 3/4, 1 HP)
- Air gap and dishwasher drain tie-in
- P-trap and tailpiece replacement
- Noise reduction and insulation tune-up
Four steps, every time.
Consistent process is why our work holds up. Here's the order of operations on a garbage disposal service call.
- 01Diagnose under the sink
Hum with no spin is almost always a stuck impeller. Leak location tells us flange vs housing. Two minutes to know what's wrong.
- 02Repair when it makes sense
A $20 part on a 3-year-old disposal. Skip the new unit if we can save it.
- 03Swap clean when it's time
New mounting assembly, fresh plumber's putty, correct dishwasher knockout handling, air-gap verified.
- 04Run-test under real load
Ice cubes, running water, full 30-second run. If it doesn't pass, we don't leave.
"Called at 9pm on a Tuesday with a leak under the kitchen sink. A plumber — not a receptionist — picked up, walked me through shutting off the water, and had someone at the door before 10:30. Fixed it, cleaned up, and the bill matched the quote exactly."
Fix the disposal
A licensed plumber — not a dispatcher — picks up. Most days we're at your door before lunch.